CUTIM Ultra-Bright LED Projection Logo Puddle Lights for Tesla | CUTIM

Make a Grand Entrance Every Time

Elevate your Tesla experience from the moment you open the door. Our Ultra-Bright LED Puddle Lights replace the dim factory under-door lamps with high-definition, crisp Tesla "T" logo projections. Not only do they provide a sophisticated aesthetic, but they also offer superior illumination for the ground beneath your feet, helping you avoid puddles and debris in low-light conditions.

Why Choose CUTIM Projection Lights?

• High-Definition Quartz Glass Lens: Unlike cheap plastic lenses that yellow and blur over time, we use multi-layer quartz glass. This ensures the logo remains sharp, vibrant, and distortion-free for years of use.

• Plug-and-Play Simplicity: No wiring, no splicing, and no drilling. Our lights are designed to be a direct 1:1 replacement for the OEM housing, utilizing the factory connector for a 2-minute installation.

• Overheat Protection: Engineered with advanced aluminum heat-sink backing and an intelligent decoding chip to prevent the common "window-drop" errors associated with low-quality aftermarket lights.

Key Features

• Upgraded LED Architecture: Utilizing high-efficiency CREE LED chips, these lights provide maximum brightness with minimal power consumption, ensuring they stay cool to the touch.

• Seamless Interior Integration: The housing is precision-molded to fit perfectly into the door panels of the Model 3, Y, S, and X without any gaps or rattling.

• Enhanced Safety: The extra-wide light spread provides a much safer exit for passengers by clearly illuminating the curb and ground in total darkness.

• Ghost Shadow Effect: The high-contrast projection creates a stunning "floating" logo effect on asphalt, concrete, or tile surfaces.

How to Install

• Step 1: Pry Out the Original: Use the provided plastic trim tool to gently pop out the factory light from the bottom of the door panel.

• Step 2: Disconnect the Cable: Press the small clip on the connector and pull the wire away from the old light.

• Step 3: Connect CUTIM Light: Plug the factory cable into the new CUTIM LED projection light. You should hear a distinct "click."

• Step 4: Snap into Place: Push the new light housing back into the door panel until it sits flush.

• Step 5: Test: Open the door and enjoy your new high-definition entrance! (Repeat for other doors).

Specifications

• Material: High-Temperature Resistant ABS + Aluminum Heat Sink.

• Lens: 6-Layer Nano-Glass Lens (Fade-Resistant).

• Light Source: CREE High-Power LED.

• Voltage: 12V DC.

• Package Options: Available in sets of 2 or 4.

Compatibility

• Tesla Model 3 / Highland: All Years.

• Tesla Model Y: All Years.

• Tesla Model S: 2012 – 2026+.

• Tesla Model X: 2016 – 2026+.

Disclaimer

All references to other companies or trademarks are for identification only. cutimauto.com is not affiliated with or endorsed by Tesla Inc.